Products

AEM's Bosch 4.9LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM wideband air/fuel UEGO controllers. These sensors have a laser-etched, calibrated resistor in...

AEM's Bosch 4.2LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM wideband air/fuel UEGO controllers. These sensors have a laser-etched, calibrated resistor in...

AEM's Air Inlet Temperature Sensor Kits (AIT) senses the air temperature on the inlet side of the engine.30-2014: Air Temp Sensor with 1/8" NPT Male Thread, High Performance DTM-Style Connector, Aluminum Bung, Connector & PinsFeatures: Senses the air temperature on the inlet side of...

Genuine, new Bosch Wideband Knock SenorSensor wiring:You must use shielded wire for signal wires, this includes knock sensor signals. Use a 2conductor shielded wire and connect one conductor to the sensor ground pin on the Ecu. Sensor polarity does not matter. Connect the shield...

Genuine, new Innovate Bosch Wideband Oxygen Sensor LSU 4.2One of the most critical sensors you'll need. 5-Wire Replacement Sensor For the LM-1 and LC-1

APPLICATION:Porsche 911 Turbo/Turbo S (2016-2019) POWER GAINS:+100 Horsepower +118 Ft-lbs. Torque (Turbo)+60 Horsepower +89 Ft-lbs. Torque (Turbo S) * Please Note: For customers who are not local, you must ship your ecu to us or send the stock .bin or .ori file via email.This service...

This Link MAP sensor reads up to 3 Bar absolute pressure. This means that it is suitable for turbo or supercharged applications running up to 2.0 Bar (or 29psi) of boost pressure. The wiring pinout for this sensor is indicated on the sensor.Easy calibration...

The Link 4 Bar MAP sensor reads up to 4 Bar absolute pressure. This means that it is suitable for turbo or supercharged applications running up to 3.0 Bar (or 44psi) of boost pressure. The wiring pinout for this sensor is marked directly on...

Easy calibration setup in all LINK Ecu's. Also, It is universal which means it can work with any ECU - not just LINK!Includes 2-pin Deutsch DTM connector kit1/8" NPT Thread

Easy calibration setup in all LINK Ecu's. Also, It is universal which means it can work with any ECU - not just LINK!Includes 2-pin Deutsch DTM connector kit1/8" NPT Thread

Looking to run flex-fuel? Then the Ethanol Content Sensor is a must have. The Ethanol Content Sensor measures the ratio of ethanol to petrol in a flex fuel vehicle. This sensor also measures fuel temperature. Compatible with all current Link Wire-In and Plug-In ECU's....

Easy calibration setup in all LINK Ecu's. Also, It is universal which means it can work with any ECU - not just LINK!Oil or Fuel pressure10 Bar/150psi1/8" NPT ThreadIncludes plug and pin kitUp to 150 PSI above atmospheric pressure, cannot be used to read...